tunnel problems with ayiya, behind NAT
Shadow Hawkins on Tuesday, 20 June 2006 12:23:44
it's probably just a setup problem on my side but i can't find almost anything on ayiya setup on the SixXS site
i'm behind a NAT (Linksys BEFVP41 V2)
i removed the sections from the autotest that looked OK to shorten the post
Unknown configuration statement on line 24: "behindnat"
Succesfully retrieved tunnel information for T2516
#######
####### AICCU Quick Connectivity Test
#######
####### [1/8] Ping the IPv4 Local/Your Outer Endpoint (ayiya)
### This should return so called 'echo replies'
### If it doesn't then check your firewall settings
### Your local endpoint should always be pingable
### It could also indicate problems with your IPv4 stack
Ping request could not find host ayiya. Please check the name and try again.
######
###### [7/8] Traceroute6 to the central SixXS machine (noc.sixxs.net)
### This confirms that you can reach the central machine of SixXS
### If that one is reachable you should be able to reach most IPv6 destinations
### Also check http://www.sixxs.net/ipv6calc/ which should show an IPv6 connection
### If your browser supports IPv6 and uses it of course.
Tracing route to noc.sixxs.net [2001:838:1:1:210:dcff:fe20:7c7c]
from 2001:838:300:17a::2 over a maximum of 30 hops:
1 * * * Request timed out.
* shortened list *
30 * * * Request timed out.
Trace complete.
######
###### [8/8] Traceroute6 to (www.kame.net)
### This confirms that you can reach a Japanese IPv6 destination
### If that one is reachable you should be able to reach most IPv6 destinations
### You should also check http://www.kame.net which should display
### a animated kame (turtle), of course only when your browser supports and uses IPv6
Tracing route to www.kame.net [2001:200:0:8002:203:47ff:fea5:3085]
from 2001:838:300:17a::2 over a maximum of 30 hops:
1 * * * Request timed out.
* shortened list *
30 * * * Request timed out.
Trace complete.
######
###### ACCU Quick Connectivity Test (done)
### Either the above all works and gives no problems
### or it shows you where what goes wrong
### Check the SixXS FAQ (http://www.sixxs.net/faq/
### for more information and possible solutions or hints
### Don't forget to check the Forums (http://www.sixxs.net/forum/)
### for a helping hand.
### Passing the output of 'aiccu autotest >aiccu.log' is a good idea.
Posting is only allowed when you are logged in. |