Foundry BigIron tunnel routing
Shadow Hawkins on Monday, 17 July 2006 17:17:46
hi folks,
we have a BigIron RX-8 which i'm trying to configure as a router via a sixxs tunnel. the relevant config is:
vlan 1 name DEFAULT-VLAN
router-interface ve 1
ipv6 unicast-routing
ipv6 route 2000::/3 2001:4830:1700:2c::1
interface ve 1
port-name Public vlan virtual interface
ipv6 address 2001:4830:1714:1::/64 eui-64
ipv6 enable
ip address 207.142.131.226/26
interface tunnel 1
port-name IPv6 tunnel to SIXXS Atlanta
tunnel mode ipv6ip
tunnel source ve 1
tunnel destination 216.10.93.2
ipv6 address 2001:4830:1700:2c::2/64
ipv6 enable
however, it doesn't seem to route any packets via the tunnel for hosts on vlan 1, even though the switch itself is reachable. incoming traceroute:
traceroute to 2001:4830:1714:1:207:142:131:221 (2001:4830:1714:1:207:142:131:221) from 2001:1b40:0:1102:d993:5eab:0:aaab, 30 hops max, 16 byte packets
1 rbii-lon-ded-gw.ipv6.blackcat.net.uk (2001:1b40:0:1102::1) 0.685 ms 0.579 ms 0.534 ms
2 rbi-rt2-e3.ipv6.blackcat.net.uk (2001:1b40:0:12::2) 0.533 ms 1.037 ms 1.066 ms
3 1d-uk6x.ipv6.btexact.com (2001:7f8:2:1::1d) 1.55 ms 1.552 ms 2.05 ms
4 52.ge0-0.cr2.lhr1.uk.occaid.net (2001:4830:fe:1100::2) 2.043 ms 2.039 ms 2.035 ms
5 v3323-mpd.cr1.ewr1.us.occaid.net (2001:4830:fe:1010::2) 75.036 ms 76.505 ms 75.425 ms
6 ge-0-1-0.cr1.iad1.us.occaid.net (2001:4830:ff:f150::2) 81.056 ms 81.908 ms 81.388 ms
7 5.ge-0-0.cr1.atl1.us.occaid.net (2001:4830:ff:e250::2) 97.273 ms 97.195 ms 96.79 ms
8 sixxs-atlnga-gw.customer.occaid.net (2001:4830:e7:2::2) 97.934 ms 97.317 ms 96.65 ms
9 * * *
outgoing traceroute:
traceroute to itanic.attenuate.org (2001:1b40:0:1102:d993:5eab:0:1) from 2001:4830:1714:1:230:48ff:fe72:e732, 30 hops max, 16 byte packets
1 csw5-pmtpa.wikimedia.org (2001:4830:1714:1:20c:dbff:fede:b600) 664.176 ms 0.278 ms 0.229 ms
2 * * *
did i miss something in the config, or is this not support on the BigIron?
Foundry BigIron tunnel routing
Shadow Hawkins on Wednesday, 20 September 2006 18:08:41
okay, we found the answer for this: IPv6 is not fully supported in RX 2.2.x; apparently it will be in 2.3.x.
Posting is only allowed when you are logged in. |