IPv6 Tunnel setup on a Vigor 2130n
Shadow Hawkins on Monday, 30 May 2011 11:52:21
Hi All,
This is my first post on the forum so hi everyone. I have a Vigor 2130n and am trying to set up a tunnel from it using my new tunnel credentials. Ive searched for other posts and help on this but not got very far so am asking for help from the community?
I have a tunnel but no assigned subnet which im not sure about, surely the tunnel will give my Vigor the address on a /64 and it will use that to give other machines connected to it something from the same range?
anyhow my main issue is what settings to put where to get the vigor up and running? my options are....
Static IPv6 which asks for..
IPv6 Address
Prefix
Gateway IPv6 server
Primary and Secondary DNS server
and TSPC which isnt supported on Sixxs but asks me for?
UN / PW
Tunnel Broker
Tunnel mode 6in4, NAT, Native and Tunnel mode
Could any of your kind peeps help me out?
FYI
Tunnel Id : T####9
PoP Name : gblon02 (uk.goscomb [AS####6])
TIC Server : tic.sixxs.net (which is the default in AICCU)
Your Location : Manchester, gb
SixXS IPv6 : 2a01:348:6:4ff::1/64
Your IPv6 : 2a01:348:6:4ff::2/64
SixXS IPv4 : 77.75.104.126
Tunnel Type : Static (Proto-41)
Your IPv4 : 82.##.##.222
Just to be on the safe side ive ## some out, hope you all done mind.
Thanks
Phil
IPv6 Tunnel setup on a Vigor 2130n
Shadow Hawkins on Monday, 30 May 2011 16:08:19 I have a tunnel but no assigned subnet which im not sure about, surely the tunnel will give my Vigor the address on a /64 and it will use that to give other machines connected to it something from the same range?
Not possible: the tunnel is a point-to-point connection. You'll need a subnet. Keep the tunnel up for a couple of weeks and you'll have enough points to get one. You should be able to terminate the tunnel on a machine behind the router while you wait for your subnet: aiccu works through NAT.
Please read the FAQ.
IPv6 Tunnel setup on a Vigor 2130n
Shadow Hawkins on Monday, 06 June 2011 10:24:29
Just upgrade your Vigor to the latest firmware (1.5.1), this has a AICCU client build in :)
Posting is only allowed when you are logged in. |