|
Speedtouch 706 protocol 41 Forwarding
![[mt]](/s/countries/mt.gif) Shadow Hawkins on Saturday, 19 April 2008 20:37:24
Hi,
I would like to perform napt but when i'm performing the command
nat mapadd intf=Internet type=napt inside_addr=10.0.0.1 outside_addr=0.0.0.0 protocol=41
i'm reciving this error
Failed to add mapping : <unknown>.
Could Any One Help. My Goal is to Forward protocol 41 (6to4) To Put a tunnel up.
Regards
Etienne
Speedtouch 706 protocol 41 Forwarding
![[es]](/s/countries/es.gif) Shadow Hawkins on Wednesday, 28 May 2008 11:28:04
I've seen it's not possible to forward protocol 41. You can try forwarding all traffic to a internal IP and check if it works, other solution could be putting another network card on the machine you want to open the tunnel and use that machine as the router that will do everything. (NAT, port forwarding, etc.).
The other option is (if it's a windows machine), configure a ayiya tunnel with the aiccu tool.
Speedtouch 706 protocol 41 Forwarding
Shadow Hawkins on Wednesday, 28 May 2008 11:31:14
Just one change to the above note. The aiccu tool can be used in linux, mac and windows machines. You have no excuse to not use it... ;)
You can check it here .
Good luck.
Speedtouch 706 protocol 41 Forwarding
Shadow Hawkins on Wednesday, 28 May 2008 11:33:42
Sorry. The link is in the SIXXS page, on FAQ AICCU.
Let's see if now the link works: SIXXS FAQ about AICCU
P.D.: Sorry... An edit tool for the messages would be great
Speedtouch 706 protocol 41 Forwarding
![[at]](/s/countries/at.gif) Shadow Hawkins on Sunday, 08 June 2008 01:55:16
Have you already tried this command:
:nat tmpladd group=wan type=nat outside_addr=0.0.0.1 inside_addr=<INTERNAL-IP> protocol=41 mode=inbound
Niki
|
Posting is only allowed when you are