SixXS::Sunset 2017-06-06

Help setting up tunnel on Windows
[us] Shadow Hawkins on Friday, 30 January 2009 18:09:03
I'm runnning on Windows and cannot get the my tunnel to work. I've listed the results from ipconfig and netsh below. I went though the ten steps and everything seems to work but when I go to IPv6Calc it shows that I'm connected via v4. I'm sure it's something simple and stupid but I need some help. Any ideas..... Tunnel adapter Automatic Tunneling Pseudo-Interface: Connection-specific DNS Suffix . : IP Address. . . . . . . . . . . . : fe80::5efe:192.168.1.109%2 Default Gateway . . . . . . . . . : C:\TEMP>netsh interface ipv6 show address Querying active state... Interface 2: Automatic Tunneling Pseudo-Interface Addr Type DAD State Valid Life Pref. Life Address --------- ---------- ------------ ------------ ----------------------------- Link Preferred infinite infinite fe80::5efe:192.168.1.109 Interface 1: Loopback Pseudo-Interface Addr Type DAD State Valid Life Pref. Life Address --------- ---------- ------------ ------------ ----------------------------- Loopback Preferred infinite infinite ::1 Link Preferred infinite infinite fe80::1
Help setting up tunnel on Windows
[us] Shadow Hawkins on Friday, 30 January 2009 18:47:59
I'm not sure where to start...you said you followed the ten steps? Which ten steps are those? netsh int ipv6 sh address isn't even showing your local area connection, much less the AICCU adapter.
Help setting up tunnel on Windows
[nl] Carmen Sandiego on Sunday, 08 March 2009 23:40:34
Have you installed the openvpn TAP device?

Please note Posting is only allowed when you are logged in.

Static Sunset Edition of SixXS
©2001-2017 SixXS - IPv6 Deployment & Tunnel Broker